ENGLISH
19
When washing the collection tank, never remove the suction filter (fig. G, ref. 1)
from its housing and never direct the jet of water against the filter itself.
You are then ready to wash and dry again.
Pushing and pulling the machine:
When the drive cannot be used, to push or pull the machine easily, you must block the
electromagnetic brake by screwing up the screws (fig. F, ref. 1) .
After moving the machine, unscrew the screws to release the electromagnetic brake.
IMPORTANT
If the screws are not unscrewed, the electromagnetic brake remains inactive.
Never turn the machine on with the screws (fig. F, ref. 1) screwed up (brake
deactivated).
7. PERIODS OF INACTIVITY
If the machine is not used for some time, remove the squeegee and brushes (or abrasive
disks), wash them and put them away in a dry place (preferably in a bag or wrapped in
plastic film) away from dust.
Make sure the tanks are completely empty and perfectly clean.
Completely recharge the batteries before storing them. During long periods of inactivity,
you should charge the batteries regularly (at least once every two months) to keep them
constantly at maximum charge.
IMPORTANT
If you do not charge the batteries regularly, they may be irrevocably damaged.
8. BATTERY MAINTENANCE AND CHARGING
! DANGER
Do not check the battery by sparking.
The batteries give off flammable fumes. Put out all fires and hot embers before
checking or topping up the batteries.
Perform the operations described above in a ventilated room.
8.1. Procedure for charging using the battery charger installed by the
Manufacturer
• Raise the seat (fig. B, ref. 8) and connect the battery charge cable (fig. C, ref. 5) to the
mains power supply.
8.2. Procedure for charging using an external battery charger
• Raise the seat (fig. B, ref. 8) and connect the battery charge connector to the red
connector (fig. C, ref. 4).
• Turn the battery charger on
To Next Page
Loading...
