IPC Gansow CT70 User Manual

CT70 PEDESTRIAN SCRUBBER DRIER
Operating & Care Guide
LED Display
Ignition Switch/Stop
70 litre solution tank Potentiometer (Speed)
75 litre recovery tank Forward/Reverse
50 cm (20”) 55 cm (22”) Brush Start/Stop
60 cm (24”) 70 cm (28”) Vacuum Start/Stop
Scrub Widths. Battery Level Indicator
Recovery Tank Full
Solution Tank Empty
MACHINE OPERATION DAILY CARE
1. Fill Solution Tank. 1. Drain Recovery Tank
2. Ignition Switch On 2. Flush Recovery Tank with Clean
Water & Wipe Off Float Switch
3. Lower Brush Head by Foot 3. Remove Vacuum Filter & Wash
Pedal. Press Down & to Left with Clean Water.
4. Lower Squeegee 4. Remove Squeegee Assembly &
Clean Rubbers Thoroughly.
5. Remove Brushes or Pads & Clean
5. Select Forward Traction Solution Flow
from Centre.
6. Wipe Down Machine
6. Open Solution Flow Lever
7. Charge Batteries, On-Board or
External Charger – 24v x 20A Min.

IPC Gansow CT70 Specifications

General

Category	Scrubber
Model	CT70
Working Width	700 mm
Productivity	3150 m²/h
Battery Voltage	24 V
Solution Tank	75 l
Recovery Tank	75 liters
Tank Capacity	70 liters
Dimensions (L x W x H)	1400 x 700 x 1200 mm

Summary

CT70 Pedestrian Scrubber Drier Operating & Care Guide

Machine Operation

Instructions for operating the CT70 scrubber drier, covering solution filling, ignition, brush and squeegee deployment, traction, and solution flow.

Daily Care

Essential daily maintenance tasks for the CT70 scrubber drier, including tank draining, flushing, filter cleaning, and battery charging.

CT70 Troubleshooting Guide

Common Problems and Solutions

Addresses typical issues like no power, vacuum failure, poor drying, and floor cleaning difficulties with their respective solutions.

Squeegee Blade Maintenance

Guidance on identifying worn squeegee rubbers and how to change them for optimal performance.

Brush/Pad Replacement

Instructions for locating and changing the brushes or pads on the CT70 scrubber drier.