ENGLISH
12
• Use the handle to adjust the pressure of the centre brush on the floor (fig. A, ref. 2)
according to the type of floor and dirt to be picked up. To facilitate use of the handle,
operate with the centre brush STATIONARY. The brush is self-levelling
• Press the suction switch (fig. C, ref. 3)
• Press the centre brush switch (fig. C, ref. 4)
• Press the side brush switch (fig. C, ref. 11)
• Use the knob to adjust the number of revolutions of the side brush (fig. D, ref. 2)
• Start cleaning, manoeuvring with your hands on the steering wheel and moving the
machine forwards or backwards by pressing the pedal (fig. A, ref. 3).
IMPORTANT
To avoid damaging the surface of the floor to be treated, avoid rotating the brushes
with the machine stationary.
i INFORMATION
1450 “BATTERY” when the centre brush no longer cleans adequately, open the
bottom left flap plate and adjust the centre brush limit device (fig. X).
IMPORTANT
Each 30 minutes of work, activate the filter shaker button (fig. C, ref. 5) for 30
seconds to clean the suction filter. During this operation, the suction fan shuts off
automatically.
IMPORTANT
Avoid passing over puddles of water. If the work surface is wet, you can only
continue using the machine if you turn off the suction fan as damp/wet dirt reduces
the performance of the suction filter.
i INFORMATION
For good results, empty the debris bin often and keep the filter clean by shaking it
using the special device.
Emptying the debris bin:
IMPORTANT
When emptying the bin, always wear a mask to protect the respiratory tract from
the dust which is always present during this operation.
i INFORMATION
Before empting the debris bin, operate the filter shaker for 30 seconds to clean the
filter
! DANGER
When the debris bin is raised/lowered or rotated, there is a risk of crushing the
hands. To perform this operation, both hands must therefore be used to action the
switches.
• Turn the centre brush off by pressing the switch (fig. C, ref. 4).
• Hold down the bin raising enabling button and use the raising switch (fig. T) to
raise/lower the bin.
To Next Page
Loading...
