IPC 1404 E - Maintenance Instructions; Maintenance - General Rules

ENGLISH
13
• Move the machine with the bin raised to the required height over a waste bin, then
rotate the bin by holding the enabling button and rotation button down at the same
time (fig. U).
• After emptying the material, release the buttons (fig. U), the bin goes back to the
horizontal position.
• Close the bin using the bin lowering switch and keeping the bin raising/lowering
enabling button pressed (fig. T).
When the bin is closed, release the closing commands and the suction motor starts up
again.
• Turn the centre brush on by pressing the switch (fig. C, ref. 4).
• At this point, you can start work again.
Flap raiser
• To collect bulky solid debris, raise the flap by pressing the pedal (fig. B, ref. 5). As far
as possible, you should, however, avoid using the sweeper with the flap raised as
cleaning efficiency is reduced.
Stopping:
• Move the machine to the parking area.
• Release the machine movement pedal (fig. A, ref. 3).
• Set the accelerator to minimum using the handle (fig. D, ref. 1).
• Turn the side brushes off by pressing the switch (fig. C, ref. 11).
• Turn the centre brush off by pressing the switch (fig. C, ref. 4).
• Turn the suction motor off by pressing the switch (fig. C, ref. 3).
• Turn the ignition key (fig. C, ref. 1) to the "0" position.
• Put on the parking brake (fig. B, ref. 3).
i INFORMATION
Pushing and pulling the machine:
When you cannot use the drive, use the by-pass lever (fig. R-R1) to push/pull the
machine. After moving, put the by-pass lever back in the original position.
7. PERIODS OF INACTIVITY
• Disconnect the batteries. To optimise the working life of the battery, it should be
charged every 30/40 days. If the level of solution is low, top up with distilled water.
• Empty the debris bin.
• Clean the machine in general, see chapter MAINTENANCE INSTRUCTIONS.
• Clean the suction filter.
8. MAINTENANCE INSTRUCTIONS
! DANGER
Maintenance must always be carried out with the machine off and ignition key
removed.
All routine and extraordinary maintenance must be performed by competent
personnel or at an authorised service centre.
For all maintenance on the engine, see the instruction book.
! DANGER
Never perform any maintenance operations without first disconnecting the
batteries from the machine’s electrical circuit.