IPC CT15 - Battery Error Code Interpretation; Interpreting Battery Error Codes

GB
The electrolyte in the battery is tur-
bid (battery models only)
the battery has reached the end of the charging/
discharging cycles declared by the manufactu-
rer
replace the battery
the battery has been charged with too high a
current
replace the battery
the battery has been charged beyond the limit
suggested by the Manufacturer
replace the battery
Error codes displayed, battery version
Brush button LED (Fig. C, ref. 4), 2 fast ashes / pause / 2 fast ashes. Brush short circuit error.
Brush button LED (Fig. C, ref. 4),1 ash / pause / 1 ash. Overcurrent error
Suction button LED (Fig. C, ref. 5), 2 fast ashes / pause / 2 fast ashes. Suction motor short circuit error
Suction button LED (Fig. C, ref. 5), 1 ash / pause / 1 ash. Overcurrent error
Brush button LED (Fig. C, ref. 4) + suction button LED (Fig. C, ref. 5), ash in sync /
pause / ash in sync.
Electronic board temperature error
Brush button LED (Fig. C, ref. 4), 4 fast ashes / pause / 4 fast ashes. Brush cut-out error
Yellow battery charger control LED (Fig. C, ref. 2), 7 fast ashes / pause / 7 fast ashes. Machine on with battery charger po-
wered error, not featured on CT45
BT
Yellow battery charger control LED (Fig. C, ref. 2), 5 fast ashes / pause / 5 fast ashes. Excessive battery voltage error
Red, yellow, green battery charger control LEDs ashing, (Fig. C, ref. 2) ECS model and Roller model, exces-
sive brush motor current draw error.
40