4. Set DO-CAM in position by adjusting its body, arm, or/and camera head. Your DO-CAM is now ready for
use.
Using DO-CAM with Compatible Software
As DO-CAM is a standard UVC camera, you can use it with a variety of software as long as they recognize the video
source coming from a UVC camera. However, to fully utilize your DO-CAM, we’d recommend using it with IPEVO
Visualizer software. Visualizer offers many useful features for your lessons or presentations, such as video
recording, snapshot, and picture-in-picture.
If you’re using DO-CAM with third-party video conferencing software like Skype, Zoom, or Google Hangouts, you can
use it in conjunction with IPEVO CamControl to adjust some basic camera settings such as rotate, exposure, and
focus. You can download IPEVO Visualizer software and IPEVO CamControl from support.ipevo.com/do-cam.
Safety Information
Federal Communications Commission [FCC] Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: [1] this
device may not cause harmful interference, and [2] this device must accept any interference received, including
interference that may cause undesired operation. This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
authority to operate equipment.
This device and its antenna must not be co-located or operating in conjunction with any other antenna or transmitter.
For product available in the USA/Canada market, only channel 1~11 can be operated. Selection of other channels is
not possible.
VCCI-B
Precaution
Do not use/store the product in the following
Near heat sources
Near steam or greasy smoke
Locations with high humidity
Sandy or dusty places
File Downloads
To Next Page
Loading...
