Need help?Do you have a question about the Ipevo VZ-X and is the answer not in the manual?
Connect Micro-USB to VZ-X and a 5V/2A USB adapter for charging.
Indicators flash Green when charging, solid Green when full. Full charge takes ~9 hours (off).
On your device, connect to the VZ-X's Wi-Fi SSID.
Open Visualizer or Whiteboard and select VZ-X as the camera source.
Connect HDMI cable and Micro-USB for power to TV/projector.
Connect Micro-USB cable to VZ-X and computer USB port.
Set Mode Switch to USB/HDMI, power on, and launch Visualizer.
Turn off device, hold specific buttons, then turn on to initiate reset.
General| Interface | USB/HDMI/Wi-Fi |
|---|---|
| USB 2.0 ports quantity | USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them. |
| HDMI output ports quantity | 1 |
| Lamp type | LED |
| Control type | Buttons |
| Product color | Blue |
| Lamps quantity | 1 lamp(s) |
| Built-in microphone | Yes |
| Image freeze | - |
| Optical sensor size | - \ |
| Maximum video resolution | 3264 x 2448 pixels |
| Effective sensor resolution | 8 MP |
| Supported graphics resolutions | 1920 x 1080 (HD 1080), 3264 x 2448 |
| Mobile operating systems supported | Android, iOS |
| Power supply type | Battery |
| Quantity per pack | 1 pc(s) |
To Next Page
