Need help?Do you have a question about the IPG YLS-6000-K and is the answer not in the manual?
General| Brand | IPG |
|---|---|
| Model | YLS-6000-K |
| Category | Measuring Instruments |
| Language | English |
Mandates safety equipment operation, securing work zones, and keeping the product housing closed during operation.
Specifies the product's intended application and warns against non-intended uses or unauthorized optics.
Highlights dangers from electrical energy and laser radiation, including direct, reflected, and scattered radiation.
Details safety features like E-Stop buttons, external interfaces, and fiber break monitoring for securing danger zones.
Guides the user through the installation process of the LaserNet software on a computer.
Details the steps for safely switching the laser on and off, including humidity considerations and chiller operation.
Describes options for switching on the laser power supply, including safety interface, LaserNet, and hardwiring.
Guides on operating in TEST mode, establishing LaserNet connection, and using the control tab interface.
Details how to control laser emission and power via external interfaces and analog signals.
Explains ROBOT mode operation, beam path checks, and laser program execution sequences.
Lists the necessary system requirements for LaserNet and guides through the installation wizard process.
Details how to connect the computer to the laser via a local network, including IP address configuration.
Guides on launching LaserNet software and ensuring a proper network connection to the laser.
Provides a breakdown of the LaserNet software interface elements, including displays, tabs, and status indicators.
Explains how to create and edit laser programs using the LaserNet program editor.
Details the program editor interface for creating new laser programs and provides a list of available commands.
Provides detailed descriptions for commands used in the LaserNet program editor, like STOP, SPT, SPR, WAIT.
Emphasizes safety during maintenance, including laser radiation hazards and severe injury risks.
Provides step-by-step instructions for safely cleaning fiber connectors, including warnings and notices.
Outlines the procedure for measuring laser output power, including test points, methods, and required tools.
Details the process for measuring beam quality, including test points, methods, time interval, and tools.
Highlights safety warnings for replacement and repair work, emphasizing mains voltage and laser radiation hazards.
Provides information on replacing laser modules and the feeding fiber, including test points and time durations.
Explains how laser-related warnings and errors are displayed via LED indicators in LaserNet tabs.
Indicates where to find information on status messages, warnings, and alarms, referencing Appendix A.
Directs users to Appendix A for detailed troubleshooting and explains event logging procedures.
Details the process of downloading log files from the laser using LaserNet software for problem analysis.
Guides on saving and downloading the laser's event messages as a .txt file for support.
Explains how to download the laser's configuration overview, including parameters and firmware statuses.
Describes how to update the laser's firmware and configuration using an HPLP file provided by service.
Details the procedure for resetting critical errors, which requires a specific code obtained from IPG service.
To Next Page
