Step 6:
With the help of your assistant, carefully lift the adjustable bed frame and set it in place upright on
its legs. Excessive pressure may damage the legs. Remove all protective plastic covering.
Note: Please unplug the bed before completing this step. Check to make sure that all power cords
are clear and do not interfere with any adjustable bed mechanisms.
Step 7:
Note: Take the mattress retainer bar from packaging. Carefully insert the mattress retainer bar into
the two holes on the foot end of the bed base. (See Figure below.)
Step 8:
Plug in the adjustable base. You are ready to enjoy!
SYNCHRONIZING TWO BASES
Step 1:
Plug base A and base B (both bases) into the power source.
Step 2:
Pair remote A to base A (step 5). Then follow the same steps to pair remote A to base B. Now you
can use remote A to operate both bases simultaneously.
To Next Page