www.iprosecu.com
b. Output Test
After the external input and output hardware is installed, you can use the
"Relay Out" bottom on the live video page to test if DO / Relay Out works.
(i) On/Off Switch mode:
Click "ON", the camera will trigger the external output device. For example, your
alarm buzzer will continuously ring. You can manually break off the output signal
by clicking "OFF".
(ii) Time Switch mode:
Click "Pulse", the camera will trigger the external output device for several
seconds; the duration length is according to the "interval" setting in Output
Setting.
To Next Page
Loading...