-29-
Network >> IP Filter
The IP Filter setting allows the administrator of the camera to limit
the users within a certain range of IP addresses to access the
camera.
Start/End IP Address
Assign a range of IP addresses that are not allowed to access
the camera by entering the Start IP address and End IP address.
When you are finished, click Add to save the range setting. You
can repeat the action to assign multiple ranges for the camera.
For example, when you enter 192.168.0.50 in Start IP Address
and 192.168.0.80 in End IP Address, the user whose IP address
located within 192.168.0.50 ~ 192.168.0.80 will not be allowed to
access the camera.
Deny IP List
The list displays the range setting(s) of IP addresses that are not
allowed to access the camera. To clear the setting, select a
range of IP addresses from the list and click Delete.
To Next Page
Loading...
Need help?
General
