iQOS 3 - Technical Data

For more information about where you can drop o your waste equipment for
recycling, please contact your local city oice, your local household waste disposal
service or the shop where you purchased the product.
The local importer of the product will provide for the financing of the treatment
and recycling of waste equipment returned through these designated collection
points in accordance with local requirements.
Battery removal instructions (for disposal and recycling)
Batteries must not be removed by the consumer. At end of product life, only an
authorized recycler may safely remove batteries by using the following steps.
IQOS 3 Pocket Charger (A1504):
Step 1: The device should be fully discharged before disassembling it. Remove the
cover, then remove the screw on both sides
Step 2: Detach the charger from the hull.
Step 3: Unscrew to remove the retainer
Step 4: Detach all FPC and connector to remove the charger PCB.
Step 5: Remove battery and dispose according to local regulations.
IQOS 3 Holder (A1404):
Step 1: The device should be fully discharged before disassembling it. Remove the
front housing from the holder.
Step 2: Remove the rear housing
Step 3: Remove the power button from the holder
Step 4: Remove the glue and solder to detach the battery from the middle part and
frame. Middle part must cut open due to glue.
Step 5: Remove battery and dispose according to local regulations
Hereby, Philip Morris Products S.A. declares that IQOS 3 is in compliance with the
essential requirements and other relevant provisions of Directive 2014/53/EU. The oicial
Declaration of Conformity may be found at:
www.pmi.com/declarationofconformity
IQOS 3 Model A1504 operates within 2.402 – 2.480GHz frequency band with a maximum
RF output power of 7.0dBm.
Designed and manufactured under the authority of Philip Morris Products S.A., Quai
Jeanrenaud 3, 2000 Neuchâtel, Switzerland.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth
SIG, Inc. and any use of such marks by Philip Morris Products S.A. and its ailiates is under
license. Other trademarks and trade names are those of their respective owners.
TECHNICAL DATA
IQOS 3 Holder - Model: A1404
Battery type:
Li-ion rechargeable battery
Input: 5V 1.6A
IQOS AC Power Adaptor
Model: S52A21, S21A20, S21A22,
S21A23, S21A25, S21A27
Input: 100V-240V~ 50/60HZ 0.3A
Output: 5V 2A
USB Type C Cable
IQOS 3 Pocket Charger -
Model: A1504
Battery type:
Li-ion rechargeable battery
Input: 5V 2A
Bluetooth® 4.1