IQsocket IQSW-GSM - Temperature Alarms; Generated Alerts

2009 NETCONS, s.r.o.
Page 12 of 16
ALARM+420123456789
When alarm is activated, power
socket is making a call to
preconfigured number. When external
detector is unplugged, alarm is
activated too and is repeated each 60
seconds.
Alarm+421903801
254 – OK
Alarm – NO sensor
Alarm – NO
number!
Ctrl
ALARMOUTPUT=10
Activates switched contact/microrelay
on alarm. Can be used for siren or
anything else.
ALARMOUTPUT=10
– OK
Conf
ALARMOUTPUT?
Request for ALARMOUTPUT
configuration
ALARMOUTPUT= 15
seconds
Conf
9.2 Temperature alarms
Built-in thermometer can be used to generate temperature alarms after critical
temperature thresholds are reached. IQsocket uses low and high temperature
thresholds which are configured by TEMPON=MAX and TEMPOFF=MIN
commands. Temperature alarm monitoring is activated 10 minutes after
IQsocked is powered on.
Command
Description
Response
Type
TEMPALARM=NO
Temperature alarms are disabled
TEMPALARM=NO –
OK
Ctrl
TEMPALARM=MAX
In case of maximal temperature
threshold is reached - SMS is sent
TEMPALARM=MAX
– OK
Ctrl
TEMPALARM=MIN
In case of minimal temperature
threshold is reached - SMS is sent
TEMPALARM=MIN –
OK
Ctrl
TEMPALARM=MIX
In case of mini or maximal temperature
threshold is reached - SMS is sent
TEMPALARM=MIX –
OK
Ctrl
TEMPALARM?
Request for temperature configuration
TEMPALARM=(NO),
MAX,MIN,MIX
Ctrl
External detectors
9.3 Generated alerts
There are more ways how to inform you about detected alarm. You can be
alerted by SMS or by phone call on active alarm. Or you can be informed by
SMS on each change of logical INPUT.
Command
Description
Response
Type
ALERT=RINGON
Phone call is established to predefined
number in case of new alarm
ALERT=RINGON -
OK
Conf
ALERT=SMS
SMS is sent to predefined number in
case of new alarm
ALERT=SMS – OK
Conf
ALERT=SMSCHANGE
SMS is sent on each logic value change
to predefined number in case of new
alarm
ALERT=SMSCHANG
E - OK
Conf
ALERT?
Request for alert configuration
ALERT=(RINGON),
SMS, SMSCHANGE
Conf