IQsocket IQSW-GSM - Basic Security Settings; Security List

2009 NETCONS, s.r.o.
Page 8 of 16
In case of SMSPIN use - individually or along with security lists, it is
important to put SMSPIN command right before SMS command without any
space or special character as shown here:
pinCOMMAND (e.g.. 3366STATUS)
- With preconfigured password/SMSPIN ; SMSPIN=3366
5.1 Basic security settings
Security can be configured and viewed simply by following messages.
Command
Description
Response
Type
SECNUMBER=NO
Security phone lists are turned
off/inactive.
SECNUMBER=NO
– OK
Conf
SECNUMBER=YES
Security phone lists are turned
on/active for configured phone
numbers.
SECNUMBER=YES
– OK
Conf
SECNUMBER=LIST
Request for full list of secured
numbers.
LIST
421903123456,42
1903111222,4212
35678235
LIST - NO
NUMBER!
Conf
SMSPIN=xxxx
Configuration of SMS
password/SMSPIN.
SMSPIN=xxxx –
OK
Conf
SMSPIN=NOPIN
Using of password/SMSPIN is
deactivated.
SMSPIN=NOPIN – OK
Conf
SMSPIN?
Request for SMSPIN configuration.
SMSPIN=(NOPIN),
1234
Conf
SMSWWW=YES
Controlling by SMS from Internet is
allowed.
SMSWWW=YES –
OK
Conf
SMSWWW=NO
Controlling by SMS from Internet is
disabled.
SMSWWW=NO –
OK
Conf
SMSWWW?
Request for SMSWWW configuration
SMSWWW=(NO),Y
ES
Conf
5.2 Security list
Security list allow configuring up to 7 numbers and up to 15 digits for one
phone number.
Command
Description
Response
Type
SECNUMBER+4212
33355777
Add new number to security list.
SECNUMBER+421
233355777 – OK
Conf
SECNUMBER-
421233355777
Delete specific number from security list.
SECNUMBER-
421233355777 –
OK
Conf
NOTE: password (SMSPIN), which is use dis different than traditional PIN
code, which is usually assigned by GSM operator or assigned by user on
SIM card. It is kind of IQsocket password called SMSPIN and is used for
SMS message authentication and has the same structure as standard PIN =
4 numbers.