IQsocket IQSW-GSM - Page 6

2009 NETCONS, s.r.o.
Page 6 of 16
COMMAND (e.g. STATUS)
- with uncofigured security password/SMSPIN
There are two kinds of commands:
Control commands (labeled as Ctrl in tables)
o Used to control of the IQSW-GSM and can be used at any time. Security settings, such
as SMSPIN, permitted callers list, DO apply.
Configuration commands (labeled as Cfg in tables)
o Allows to configure the IQSW-GSM parameters and functions. Their use is limited by
time to 10 minutes after device has been powered on or after last configuration
command has been received. Security settings, such as SMSPIN, permitted callers list,
DO NOT apply.
Command are not case sensitive. Messages longer than 30 characters are
deleted without any error response.
Command
Description
Response
Type
TURNOFF
Output power socket and
microrelay are turned off
TurnedOFF
Ctrl
TURNON
Output power socket and
microrelay are turned on
TurnedON
Ctrl
TURNOFF1
Output power socket is turned
off
TurnedOFF1
Ctrl
TURNON1
Output power socket is turned
on
TurnedON1
Ctrl
TURNOFF2
Microrelay is turned off
TurnedOFF2
Ctrl
TURNON2
Microrelay is turned on
TurnedON2
Ctrl
TURNOFF=123
Output power socket is turned
off for 123 minutes. Maximal
acceptable value is 180.
TurnedOFF 123 min
Ctrl
TURNON=123
Output power socket is turned
on for 123 minutes. Maximal
acceptable value is 180.
TurnedON 123 min
Ctrl
RESTART
Changes status of output power
socket and microrelay (negation,
microrelay only if
ALARMSWITCH=0) to pre-
configured time by command
RESTARTTIME.
Restarted
Ctrl
STATUS
Request for power socket
status: output power socket
status, temperature, GSM signal
TurnedOFF, TEMP: 25C, Signal: 35
%, INPUT=NOTCONNECTED,
Time=rr/mm/dd,hh:mm:ss,
ALARM: ACT
Ctrl
CREDIT*XX#
Check credit value on SIM card
YOUR CREDIT IS xxx
Ctrl