IRIS Touch 4 NG Series - 5 Before You Start

IRIS Touch Quick Installation & Maintenance Guide Version 1.1 Page 5 of 16
5. Before You Start
Monitoring Centre (ARC)
Make sure that the monitoring centre to which the IRIS Touch device will send alarm signals is equipped
with the appropriate IRIS Secure Apps receiving system. The following information should be obtained
from the monitoring centre.
Dialler account number
Monitoring centre IP address
Ethernet Connection Details
The customer’s Ethernet (LAN) network details are required in order to connect the IRIS Touch. The
following information should be obtained from the customer.
Fixed IP address or DHCP
Fixed 
DHCP 
If using DHCP then the following information will not be
required as it will be assigned by the network.
IP address
Gateway address
Subnet mask address
GPRS/3G SIM Card and Access Point Name
If the installation uses GPRS/3G then a SIM card will be required. The IRIS Touch will also need to be given
a GPRS/3G ‘Access Point Name’ (APN) and other possible configurations as shown below. These can be
obtained from the SIM card provider.
Access Point Name (APN)
User Name (USR)
Password (PWD)
SIM Pin