Roomba
®
i5+ Owner’s Guide 9
EN
4
5
Remove the bin from the robot and clear any
debris from the vacuum path.
Reinstall the brushes in the robot. Match
the shape of the brush pegs with the shape
of the brush icons in the cleaning head
module
1
2
Cleaning the Visual Docking
Target Sensors, IR Window and
Charging Contacts
Wipe sensors and charging contacts with
a clean dry cloth. Alternatively, you can
use a pad of melamine foam to remove
built-up debris on the robot and Clean
Base charging contacts.
Inspect the visual docking target, IR
window and charging contacts to make
sure that they are clear of debris. Wipe
with a clean, dry cloth.
Important: Do not spray cleaning solution
or water onto the sensors or sensor
openings.
1
3
2
Cleaning the Multi-Surface Brushes
Remove the brushes from the robot. Remove
the brush caps from the ends of the brushes.
Remove any hair or debris that has collected
beneath the caps. Reinstall the brush caps.
Remove any hair or debris from the square
and hexagonal pegs on the opposite side of
the brushes.
Pinch the brush frame release tab, lift the tab,
and remove any obstructions.
To Next Page
Loading...
Need help?
General
