The setup guide for a Wi-Fi connected Roomba.
Follow these three simple steps to get started with a Wi-Fi connected Roomba vacuuming robot.
Step 1: Activate Roomba
In an uncluttered area, place the Home Base® charging station flat against a wall on a
level floor surface. Visit Positioning the Home Base to optimize the position of the Home
Base.
Plug one end of the line cord into the Home Base and the other into a wall outlet.
Remove the yellow bin insert and battery pull tab from beneath the robot.
Place Roomba onto the Home Base, making sure the metal charging contacts on the
Home Base match up with those underneath the robot.
If successful, you will hear a series of tones. Once the CLEAN button illuminates, Roomba is
ready for use.
Step 2: Start Cleaning Cycle
Press CLEAN once to wake up Roomba.
Press CLEAN again to start a cleaning cycle.
Roomba cleans an entire level of your home during one cleaning cycle. If its battery gets low
before finishing a cleaning cycle, Roomba automatically returns to the Home Base to recharge.
After its battery has been recharged, Roomba automatically resumes, completes the cleaning
cycle, and returns to the Home Base. If the Home Base is inaccessible, Roomba will not be able
to recharge. It will return to its starting location and the cleaning cycle will end.
Roomba ships with a partial battery charge. If you start a cleaning cycle before charging the
battery fully, Roomba may return to the Home Base to recharge sooner than it will during future
cleaning cycles.
Step 3: Download the iRobot HOME App
The iRobot HOME App allows you to use your iOS or Android smart device to help you have
the best possible experience with Roomba. To download the iRobot HOME App, search “iRobot
HOME” on the App Store or on Google Play™, or visit: iRobot HOME App
Roomba Wi-Fi Setup: Cannot activate Wi-Fi.
To Next Page
Need help?
General
