2.2 KEYS
View from front
CHANNEL / + (press briefly)
- In normal operating mode: Changes from channel to channel (
--> 1 --> 2 --> 3 --> 4 --> 5 --> --> etc)
- In the various setting modes: Increases the value to be set (hold pressed for fast run through)
MEMORY / - (press briefly)
- In normal operating mode: Call-up of the data from the thermo/hygro memory (MAX --> MIN --> MAX --> etc.)
- In the various setting modes: Reduces the value to be set (hold pressed for fast run through)
SET
- In normal operating mode: No function
- In the time setting mode: Jumps with each press from setting element to setting element
- In the thermo/hygro alarm setting mode:
a) Press briefly: Switching on/off of the HI/LO limits
b) Hold pressed: Activating the setting mode of the alarm values and change with the + or - keys.
Close again by briefly pressing the SET key.
●-----SET----●
By pressing the CHANNEL/+ and MEMORY/- keys at the same time and holding them for approx. 3 seconds, it is possible to
change into the time setting mode.
° ALARM
- Hold pressed for 3 seconds: The setting mode of the thermo/hygro alarm is activated
SEARCH
- Hold pressed for 3 seconds: For the radio channel active on the display (CH1 … CH5, flashing), a sender search is started.
This key is inactive when
is active
CLEAR
- Hold pressed for 3 seconds: For the channel active and flashing on the display (
, CH1 .... CH5), the MAX/MIN memory is
reset.
View from behind (with battery lid opened)
Battery compartment
2 x 1.5 batteries of the size UM-3 resp. ‘AA’
°C/°F switchover
When the battery compartment is opened, you will find above the CE
label a press button with which the temperature measurement unit
displayed on the LCD can be changed from ° C to ° F and vice versa at
any time and independently of the setting on the sensor. The key can
be operated with a sharp object (paper clip, tip of a pen, etc.) (single
short pressing of the key).