28
As soon as the stopwatch is started the VERTIC-LOG begins recording the
climb log.
One lap (LAP) is recorded per 100 m climbed. The first 100 m are LAP 1, the second
LAP 2 etc.
After a total of 1000 m of actual climbing (equals 10 LAPs), the time and the altitude
gain for these 1000 m is additionally stored (LAP +1000).
The same is done for the next 1000m etc. (LAP +2000, LAP +3000 etc.).
LAP 1–10
–
LAP +1000
LAP 11–20
–
LAP +2000
LAP 21–30
–
LAP +3000
etc.
Beginning the climb
To start the previously activated VERTIC-LOG function you must start the stopwatch
at the beginning of the climb you want to monitor!
Start the stopwatch and with that the VERTIC-LOG recording
Important: The recording of the climb will be interrupted when the stopwatch is
stopped. If you press the S/R button by mistake, do a “RESTART” with the S/L
button. The interrupted LAP x will be stored at its last status and a new LAP x+1 will
begin with the RESTART. If altitude was gained during this time it is lost to the
VERTIC-LOG recordings. To avoid unintentionally operating the STOP button (S/R)
we recommend activating the key lock.
To Next Page
Loading...