25
ZERO MY20
EN 428001318037
Use and maintenance manual
14.2 PRELIMINARY CELL CLEANING
Before starting the machine, it is necessary to perform thorough cleaning inside the cell using a soft cloth and a neutral detergent.
It is advisable not to use stainless steel wool pads, scrapers or abrasive, acidic or aggressive substances that could irreparably
damage the stainless steel surfaces.
At the end of the cleaning, perform thorough rinsing and drying.
14.3 MANUAL OPERATION WITH “HEATED NEEDLE PROBE”
The needle probe is a device that is housed in the equipment and is used to detect the temperature in the centre of products.
When the core probe detects that the temperature in the centre of the product has reached the set temperature, it
automatically stops the appliance from operating in the manual function with the needle probe.
For use, the needle probe must be inserted into the food before starting the cycle.
ATTENTION
The core needle probe must be inserted deeply into the centre of the product, making sure that it does not come out as
indicated below.
It must be handled with care as it is pointed.
At the end of the cycle, put it back in the holder after cleaning it with a soft cloth and warm water.
ATTENTION
If there are products of different sizes, insert the probe into the larger piece.
YES
NO NO
To Next Page
Loading...