TU320F
&
TU324F
I
I
Lubrication of
each
part
Ambient temperature
Viscosity
o
Replacement
of
the
and oil replacement
Higher than
25°C
SAE30
transmission
gear
oil
Use those recommended by
Oto25°C
SAE20
or IOW/30
1)
Remove the drain plug on
the bottom
of
the transmis-
ISEKl or other good quality
Lower than 0 °C SAEIO
sion case to drain used oil.
oil
of
viscosity specified
below and refer to the periodi
\ j
Drain
plug
cal maintenance chart about Note:
quantity required and the
Be sure to use the same kind
Tii~)t'J)
r
replacing intervals.
of
oil as that already in the
~t~
engine for replenishment.
0
Replacement
of
engine oil
o Replacement
of
the
front
__
D_rae--in
plug
Note:
Be sure to use the same kind
of
oil as that already in the
transmission case
for
replen-
ishment.
Usable oil: Gear oil of SAE80
Upper
limit
3) Reinstall the removed drain
plugs securely and pour oil up
to the specified level on the
dip stick. (17 liters)
2) Remove the drain plug on the
bottom side wall of both rear
axle housings to drain used oil
from the axle housings.
~Ug
reduction
gear
box
Remove the drain plug in the
bottom of the gear box to
drain used oil. Retighten the
drain plug. Then remove the
cover and pour fresh oil
through the filler until oil
starts overflowing through the
level plug hole (0.5 liter).
Usable oil: Gear oil of SAE80
Note:
Be sure
to use the same kind
of
oil as that already is the
reduction gear box for replen-
ishment.
Remove the dram plug
in-
stalled in the bottom
of
the
engine oil pan to drain used
oil. Then retighten the drain
plug and pour fresh oil
through the oil filler up to the
upper limit on the dip stick.
(4.3 liters)
Level
gaug~
Upper
limit
Use oil
of
the proper viscosity
in accordance with the ambi-
ent temperature. When
shipped, the tractor is filled
with oil of SAElOW/30.
-33-
To Next Page
