very hot and may cause burns.
o Adjusting method
Loosen the alternator tighten-
ing bolt and adjust the belt
tension by shifting the alterna-
tor. After adjustment, be sure
to retighten the bolt.
Inspection
and
adjust-
ment of the air
cleaner
Inspect and clean the air
cleaner
in the following way.
o Cleaning
of
the vacuum
valve
Open the bonnet and remove
the right-hand fan cover.
Pinch the valve to release
accumulated dust. When
sediment is wet, wipe the
valve clean with cloth.
o Cleaning
of
the element
Filter
element
V
rr:;;~I'-<'.
,-
1) Remove the wing bolt to draw
the element.
2) Clean the element in the
following way.
• When clogged with dry dust,
dust
off
the element by tap-
ping it lightly by hand or blow
dust away with compressed
air. When using compressed
air, be careful not to damage
the element.
• When clogged with wet or
oily dust, immerse the
element in a neutral synthetic
detergent solution for about
30 minutes and then rinse it
softly in fresh water. Let it dry
naturally.
3) After cleaning, install the
element into the cleaner.
Note:
1) Never hit the element against
a hard object like a stone,
concrete wall, etc.
2) Tighten the element securely.
3) Each part should be tightened
securely to be airtight.
o Replacement
of
the element
Replace a damaged element or
an element which has already
been washed five times.
-38-
TU320F
&
TU324F
Inspection of piping
Consider pipes such as the
fuel line, radiator hose, hy-
draulic rubber pipes as con-
suming parts. Replace dam-
A:'
immediately
Caution:
• A broken fuel line allows fuel
to leak, which may result in
fire.
• A broken radiator hose lets
boiling water gush out, which
may cause burns.
Inspection of the electric
wiring
and
fuses
o Inspection
of
the wiring
1) Loose terminal connections
lead to open circuits, damaged
wiring may reduce the per-
formance
of
the electric
apparatus, and a short circuit
may result in fire. Therefore,
fatigued or damaged wiring
should be replaced immedi-
ately.
2)
If
a replaced fuse shorts
quickly, never replace the
burnt fuse with wire, but
consult your dealer immedi-
ately.
3) Broken wiring covering
should be repaired with
insulation tape immediately.
4) Wiring separated from its
clamp should be repaired
immediately.
To Next Page
