How to fix a cream charger that won't puncture in my iSi Dessert Whip PLUS Kitchen Appliances?
If the cream charger will not puncture in your iSi Kitchen Appliances whipper, ensure that you are using original iSi cream chargers. If you are using the correct charger, make sure it is inserted correctly according to the instructions. If the issue persists, the puncturing unit may be damaged, and the whipper should be sent to iSi or a service center.
What to do if the content from my iSi Dessert Whip PLUS Kitchen Appliances whipper is too runny?
If the content dispensed from your iSi Kitchen Appliances whipper is too runny, it could be due to several reasons. First, the whipper might have been overfilled. To fix this, release the pressure, pour out the excess liquid, and then set up the whipper again. Another reason could be that the whipper was not shaken enough. Also, ensure the content is cold enough by placing the filled and prepared iSi whipper in the refrigerator for at least 1-2 hours. Lastly, make sure you are using original iSi cream chargers, as an unsuitable charger could also cause this issue.
Why is gas leaking from my iSi Kitchen Appliances between the bottle and the head?
If gas is leaking between the bottle and the head of your iSi Kitchen Appliances during operation, there are several possible causes. First, check if the head gasket is missing and insert it into the head. If the head gasket is damaged, it needs to be replaced with an original iSi spare part. Ensure the head is tightened securely onto the bottle by hand, following the instructions. Lastly, inspect the bottle for damage on the upper edge. If damaged, send the whipper to iSi or a service center.
What to do if gas leaks through the dispensing piston of my iSi Dessert Whip PLUS?
If gas is leaking through the dispensing piston or adapter during operation of your iSi Kitchen Appliances, ensure that the adapter is attached to the dispensing piston before screwing on the charger. If the adapter is correctly attached and gas is still leaking, the dispensing piston seal may be damaged and needs to be replaced with an original iSi spare part.
Why can't I remove the content from my iSi Dessert Whip PLUS whipper and it sprays?
If you cannot remove the content or the iSi Kitchen Appliances whipper sprays, it could be due to several reasons. It may be caused by a blockage from undissolved ingredients like sugar. In this case, release the pressure and clean the whipper, ensuring all powdered ingredients are completely dissolved. If the cream has become too stiff, decrease the intensity and frequency of shaking next time. If the content is too firm due to over-cooling, let the whipper stand at room temperature for 5-10 minutes and avoid freezing the content. Also, ensure you are using original iSi cream chargers and operating the whipper headfirst with a vertical decorator tip to maintain pressure. Finally, make sure you are not using too many chargers, referring to the Whipper Data for the maximum number. If too ma...
Register your product online to extend the warranty period for materials and machining.
Steps for preparing the iSi Whipper before assembly and filling.
Guide to assembling the iSi Whipper components and inserting the charger.
Procedure to safely release pressure from the iSi Whipper before disassembly.
Addresses issues like blockages, stiff preparations, or insufficient pressure.
Solutions for gas leaks from the connection between the bottle and the head.
General| Dishwasher Safe | Yes |
|---|---|
| Material | Stainless Steel |
| Capacity | 0.5 liter |
| Compatible Chargers | iSi 8g chargers |
| Usage | Whipping cream, desserts |
| Charging Mechanism | N2O chargers (8g) |
To Next Page