Why can't I use my iPod click wheel with iSimple Gateway?
If you can't use your iPod's click wheel to select music with the iSimple Gateway, it's likely because the iPod is in external control mode. To regain control via the click wheel, press the Aux/Sat button and select the AUX source.
What to do if radio shows 'DEV Media Gateway INIT' on iSimple Gateway?
If your radio displays “DEV Media Gateway INIT” with the iSimple Gateway, wait a few minutes. Then, cycle the ignition off and on, and enter SAT mode.
Why does my iSimple Gateway say iPod not connected?
If your radio shows 'iPod not connected' when using the iSimple Gateway, the issue is likely that the iPod cable isn't properly connected. Verify that the docking cable is securely connected to both the iPod and the Media Gateway.
Why is there only static when using AM/FM radio with iSimple Gateway?
If you experience only static and no audio when listening to the factory AM or FM radio with the iSimple Gateway, it's because the factory antenna cable is connected to the HD radio tuner. Use the Media Gateway to access the HD radio source, which will provide AM and FM reception for your vehicle.
How to reset iPod for iSimple Gateway control issues?
If you're still experiencing control issues with your iPod and iSimple Gateway after updating the firmware, the iPod may need a reset. Press and hold the center click and menu buttons simultaneously for 10 seconds to reboot the iPod. Note that this reset will not cause you to lose any music.
Why is there no AM/FM reception with iSimple Gateway HD radio source?
If you're not getting any AM or FM reception through the HD radio source on your iSimple Gateway, it's likely that the factory antenna cable isn't connected to the HD radio tuner (HDRT). Remove the factory antenna plug from the factory radio and connect it to the HDRT module.
How to display iPod info on iSimple Gateway text screen?
If you are not seeing iPod artist or song information on the text screen with the iSimple Gateway, it may be that the radio is displaying a different text field. Press the display button to view the correct text field.
How to browse iPod correctly with iSimple Gateway?
If you're having trouble browsing your iPod through the radio with the iSimple Gateway, the iPod firmware may be outdated. Update the iPod firmware.
What to do if iSimple Gateway doesn't recognize HD tuner?
If the Media Gateway isn't recognizing the HD tuner (HDRT), it's possible the HD tuner wasn't properly connected when the PXAMG was first connected and initialized. Disconnect the PXAMG from the vehicle harness for at least 5 minutes. Ensure the 8-pin DIN HDRT cable is securely connected at both ends before reconnecting the vehicle harness.
Why does iSimple Gateway HD radio quality fluctuate?
If you notice that the HD radio station quality fluctuates or is lost randomly when using the iSimple Gateway, it's likely because the HD tuner is temporarily losing reception of the Digital HD radio broadcast signal. The digital HD radio playback should resume when you are in areas with higher broadcast signal strength.
Advises disconnecting the vehicle battery and iPod during installation and use.
Crucial safety advice to disconnect the vehicle's battery before electrical work.
Instructions for operating HD Radio, including tuning, bands, and presets.
Detailed controls for iPod playback, navigation, and browsing.
Operating the iPod function on both navigation and non-navigation 2009 systems.
General| Brand | iSimple |
|---|---|
| Model | PXAMG |
| Category | Car Receiver |
| Connection | Wired |
| iPod Control | Yes |
| Auxiliary Input | Yes |
| SAT Radio Ready | No |
| Input Voltage | 12V DC |
| Weight | 1 pound |
| Features | iPod/iPhone control and charging, auxiliary audio input |
To Next Page
