13
Setting
P01: Backlight brightness: Level 1 means the darkest and level 3 means the
brightest.
P02: 0：KM；1：MILE；Odometer unit.
P08: Speed limit: 0-50 KM/H, 50 means no speed limit.
1.Non-communication state (computer control): When the speed is higher than the
set speed, The PWM output will be turned off; When the speed drops below the set
speed, The PWM output will be automatically turned on, And the drive speed is the
current speed ± 1 KM/H (No speed limit in throttle mode)
2.Communication state (Controller control): The drive speed is maintained at the set
value, Error: ±1 KM/H (Both PAS mode and throttle mode have speed limit)
Note: The speed limit value here is based on the unit of KM/H. After the unit is
switched from KM/H to MPH, The speed value on the display will automatically be
converted to the correct MPH value. But if the value set in this menu is based on
the unit of MPH, After the unit is switched to KM/H, The value will not be converted;
P16: Zeroing: Press and hold the increase button for 5 seconds to reset ODO.
Description of Button Operations
Button operations include short pressing one button, Long pressing one button, And
long pressing multiple buttons simultaneously.
Short press is used for fast and frequent operations, Such as:
There is no short pressing multiple buttons which is easy to trigger and difficult to
operate.
● 1. In riding, Short press the buttons to change PAS level or speed limit.
● 2. In riding, Short press the M button to switch to multi-function section.
Long pressing the M button is mainly used to switch mode and power on/off.
Long pressing multiple buttons is used for parameter setting, Because the
operation is complicated, it can reduce misoperation.
To Next Page
Loading...
