14
Long press ,Switch speed unit.
(Assuming it is in PAS drive mode)
1.1 Short press ,PAS level + 1.
Specific Operation Instructions:
● 1. Change PAS level or speed limit.
1.2 Short press ,PAS level - 1.
6.1 Long press the M button to save the current value and the parameter stops
blinking.
6.2 Short press the M button to switch to the next parameter and the value of the
previous parameter will be saved.
6.3 Press the increase button and decrease button to exit setting and save the
parameters. If no operation for 10 seconds, It will exit and save the parameters
automatically.
● 2. Switch speed unit.
M
+
When the bike is stationary, Press and hold the decrease button to enter walk assist
mode, Letting it go will exit walk assist mode.
When in P16 menu interface, Long press increase button for 5 seconds to reset the
odometer.
● 3. Enable/disable 6 KM/H walk assist mode, Turn on/off front light, Zero ODO.
If the display is on, Long press the M button will turn it off; If the display is off, Long
press to turn it on.
● 4. Turn on/off LCD display.
Short press to switch items in multi-function section.
● 5. Switch multi-function section information.
Long press the increase button + decrease button to enter parameter setting
interface, You can set parameters such as wheel diameter (inch), Number of
magnetic steel, LCD brightness, And under-voltage value (See setting: P01-P16);
(In setting interface, Short press the increase button or decrease button to adjust
the value. The parameters will blink after adjustment.)
● 6. Parameter setting.
To Next Page
Loading...
