Assembly
Electric Skateboards/ Scooter
Electric Skateboards
1. Electric skateboard assemble: Put the mounting nut into the front axle slot, and
insert the axle screw into the wheel and mounting nut, then use the Allen wrench to
tighten the axle screws of both sides.
2. Electric scooter assemble: Open the front rubber cover and insert the handlebar
into the skateboard to the end, when you hear a click, it means it is in the right place.
3. Electric scooter disassembles: Press down the bottom elastic clasp and pull the
handlebar out of the skateboard.
4. Adjust the scooter height: Open the latch press the elastic clasp on the handlebar
and adjust the height meanwhile, then close the latch.
Latch
Soft Rubber Cover
Handlebar
Elastic Clasp
Brake Pedal
Accelerator Pedal
Front Wheel
Front Axle Screw
Allen Wrench
Mounting Nut
Charging Port Power Switch
- 03 -
To Next Page
Loading...
