eIcons - eJimi www.islabikes.co.uk
Factors that can reduce product lifespan include:
Impacts to the bike from crashes, bumps or jumps.
Exceeding the maximum weight limit for the bike.
High mileage/usage.
Environmental conditions (unusually damp/saline atmosphere,
muddy or sandy conditions).
Poor maintenance and use out of correct adjustment.
Unsympathetic riding style.
Factors that can increase product lifespan include:
It is not possible to make a bike that is never going to be damaged.
If you use the bike beyond its limitations, there is a high risk of
failure which could result in serious injury or death. Bikes that are
used competitively should be subject to more frequent and rigorous
checks. Take particular care to check the frame tube junctions and
welds as well as all the components for damage or excessive wear.
If in any doubt, please contact our technical support team on +44
(0)800 008 6297 or email techsupport@islabikes.co.uk. Or take it to
a qualied cycle mechanic for inspection.
Never use your eIcon as a method of towing any other person,
vehicle or object.
Usage guidelines Rear wheel removal
Your eIcons bicycle uses a rear hub motor which consequently requires a
slightly dierent procedure for removing the rear wheel:
Ensure that the electronic system is switched o via the iWoc
Trio controller.
You must always disconnect the motor cable before doing any
maintenance or servicing work on the rear of the bicycle. Failure to
do so is highly likely to result in serious injury!
1. Shift into the 10th gear of the cassette. This is the smallest ring on
the cassette.
2. Undo the rear axle nuts using an 8mm allen key and remove the
location washers.
3. Pull wheel down from dropouts.
OK
To Next Page
Loading...
