ISM SV-260 User Manual

SV-250 ( SV-260 )
INSTRUCTION MANUAL
使用說明書 rev – 9e
For safe operation
重 要 安 全 事 項
1.Prior the use of this product, please read the instruction Manual. Keep this Instruction Manual and the user
may read it at anytime when necessary.
使用本產品前,請先閱讀本說明書;同時應將此說明書妥善保管以便能隨時查閱 .
2.Before turn on the power, be sure to check the power voltage and phase agreeing with the nameplate that
indicated in the control box.
電源開啟前,請先確認電源的電壓與相數,是否與控制箱銘牌相符.
3. Grounding the machine is always necessary for safe and normal operation.
為了正常安全運轉,須安裝地線.
4. Check lubricating oil prior to operation.
操作前,請先確認縫紉機潤滑油充足.
5. Check that rotational direction of the motor is correct prior to operation.
操作前,請先確認馬達轉動方向正確.
6. So as to prevent personal injuries during operation, be careful not to allow your head and hands to come
close to the moving parts. Also never try to stop it with external forces.
使用中,切勿將頭,手靠近皮帶輪,皮帶,旋梭,天平等移動部份;同時也不可以用外力,強制停止移動部份
.
7. For the following conditions, turn off the power or disconnect the power plug from receptacle.
發生下列情況時,應立即關閉電源開關或者拔下電源插頭:
7.1 For threading needle or replacing bobbin.
穿線和更換旋梭時.
7.2 To plug or unplug any connectors from control box.
插拔控制箱上任何連接線與接頭.
7.3 For maintenance and repairing.
保養與修理時.
7.4 When machine is not at use, inspected or adjusted.
翻抬針車頭,取下皮帶時. 機器休息不用時.
7.5 When lightning and thunder occurs.
打雷閃電時.
8. Repairing, remodeling and adjusting works must only be done by appropriately trained technicians
or specially skilled personnel.
本產品的修理,改造,調整;應由受過專門訓練的技術人員來進行.

ISM SV-260 Specifications

General

Ignition System	CDI
Fuel System	Carburetor
Cooling System	Air-cooled
Starting System	Recoil
Fuel Type	Gasoline

Summary

General Safety Precautions

Read Instruction Manual

Always read the instruction manual before using the product.

Check Power Voltage and Phase

Ensure power voltage and phase match the nameplate before turning on.

Machine Grounding

Proper grounding is always necessary for safe and normal operation.

Check Lubricating Oil

Check Motor Rotational Direction

Avoid Contact with Moving Parts

Keep head and hands away from moving parts to prevent injury.

Power Off Conditions

Turn off power for threading, connector changes, maintenance, or lightning.

Initial Setup and Wiring

Connecting the Control Box Cord

Connect the specified lines to the appropriate positions on the PCB.

Operating the Sewing Machine

Speed Unit Adjustment

Adjust the speed unit's neutral position after replacement.

Error Handling and Indicators

Error Message Display and Troubleshooting

Displays error codes and corresponding items to check for troubleshooting.

Parameter Configuration and Settings

Parameter Setting Procedure

Guide to setting parameters using the control panel keys.

Motor Pulley Ratio Measurement

Machine Type Selection

Pedal Sensor Neutral Point Setting

Mode for setting the neutral point of the pedal sensor.