2
SECTION 1 –SAFETY INFORMATION
Safety Information
Understand and follow operating instructions carefully.
Use the instrument only as specied in this manual; otherwise, the protection provided
by the instrument may be impaired.
WARNING
Identies hazardous conditions and actions that could cause BODILY HARM or DEATH
CAUTION
Identies conditions and actions that could DAMAGE the instrument or equipment
under test
WARNING
- Examine the instrument and probes before use. Do not use the instrument if it is
wet or damaged
- When using test leads or probes, keep your ngers behind the nger guards.
- Remove the test lead from the instrument before opening the battery cover or
instrument case.
- Always use the correct terminals, switch position and range for measurements.
- Never attempt a voltage measurement with the test leads inserted into the
“A”input terminals.
- Verify the instrument is operating correctly by measuring a known voltage before
use. If in doubt, have the instrument serviced.
- Do not apply more than the rated voltage, as marked on the instrument, between
terminals or between any terminal and earth ground.
- Do not attempt a current measurement when the open-circuit voltage is above
the fuse protection rating.
- Only replace a fuse with the correct type and rating as specied in this
instruction manual.
- Use caution when measuring voltages above 30 Vac rms, 42 Vac peak or 60
Vdc. These voltages pose a shock hazard.
- To avoid false readings that can lead to electric shock, replace the battery as
soon as the low battery indicator appears in the display.
- Disconnect the circuit power and discharge all high-voltage capacitors before
making resistance, current, continuity, diode or capacitance measurements.
- Do not use the instrument in a hazardous area or around explosive
gasses or vapours.
- Wear suitable personal protective equipment when working around or near
hazardous live conductors which could be accessible.
To Next Page
Loading...
Need help?
General
