5.3 Battery Hardware
All battery hardware required for the installation comes with the system. When
installing the batteries and hardware, please ensure flat washers and lock washers are
used with each bolt. Ensure that the batteries jumper busbars are seated flat against the
surface of the batteries terminals before tightening and NEVER over-tighten the bolts by
ensuring that proper torque is applied to the bolts.
5.4 Battery Pre-Checks
All batteries are quality controlled and measured from the factory before shipping.
We recommend that additional measurements are made as a quick determination of
the batteries health before starting up the system. Measure all batteries in their resting
state and ensure that all batteries are within 0.10 VDC to 0.150 VDC from each other.
To Next Page
Loading...
