Prior to Installation
Before you start the installation
• Choose a suitable location for the system. Again, it must be placed on a flat surface and make
sure this system is to be installed on INDOOR cold-water supply ONLY.
• Check the packing list to confirm all accessories are included in the package. Contact iSpring
customer service if any components are missing.
• Required tools:
• Optional tools:
Variable speed drill with two bits: 1/4" (for drilling a hole on PVC drain pipe), 1/2" hollow
diamond (for drilling a hole on the countertop for drinking faucet)
5/8", 9/16" open-end wrench, or adjustable wrench, pliers
• Quick connect instruction
It is highly recommended that you watch the video ''How to Connect and Disconnect Quick
Connect Fittings | DIY Installation'' on YouTube. Cut the tubing end squarely using utility
knife or scissors. Insert the tubing into the quick connect fitting for at least 1/2''. You will need
to wiggle the tube and apply additional pressure to create a seal.
Page 3 www.123filter.com | (678) 261-7611 | support@123filter.com
To Next Page
Loading...
