Installation Tips
How to Use Quick-connect Fitting
To Connect:
1. See Figures above. Check and cut the tubing end square and clean with a utility knife or
scissors.
2. Make a mark at the end of the tubing. The length is about 1/2" - the depth of the fitting
body.
3. Fully insert the tubing until the mark is almost invisible. This ensures that the O-ring seals it
near the bottom.
To Disconnect:
1. See Figures above. Remove the blue Lock Clip.
2. With two fingers PUSHING IN and PRESSING DOWN the Lock Sleeve to eliminate the
Gap that the blue Lock Clip occupied, pull the tubing out. (Pressing down the Lock Sleeve
releases the spring-loaded steel teeth that grab the tubing inside the fitting body.)
Page 5 www.123filter.com | (678) 261-7611 | support@123filter.com
To Next Page
Loading...
