QUICK START GUIDE
The first thing you will want to do is change the Admin PIN number from the default 123456 to a unique,
secure PIN number that you will remember.
To change the Admin PIN number follow the instructions below:
1. To enter Admin Mode, first connect your drive to a USB port and wait until the LED light turns RED.
Next, press and hold 0 + UNLOCK key for 5 seconds until the LED light flashes RED
2. Enter the Admin PIN number (default is 123456) and press UNLOCK key.
The LED light will turn BLUE indicating you are in Admin Mode.
3. While in Admin Mode, press and hold 9 + UNLOCK key until the LED light flashes BLUE .
4. Enter the new Admin PIN number (minimum 6 digits) and press UNLOCK key. The LED light will flash
GREEN 3 times if successful.
5. Within 10 seconds, re-enter the new Admin PIN number and press UNLOCK key. The LED light will
stay solid GREEN for two seconds then solid BLUE indicating you have successfully changed the
Admin PIN.
6. To exit Admin Mode and begin using your iStorage diskG drive, press the CANCEL button until the
LED turns RED. Now enter your new Admin PIN number and press UNLOCK key.
*Note: PINs must be a minimum length of 6 and maximum 16 digits.
Cannot contain all sequenital numbers (2345678 or 9876543)
Cannot contain all repeating numbers (1111111)
Your iStorage diskG is preformatted in NTFS for
Windows
®
and is ready for use.
To access the diskG plug your drive into a
powered USB port (for the fastest data transfer
speeds use a USB 3.0 port - the diskAshur is
also backwards compatible with USB 2.0), enter
the default PIN number of 123456 and press
UNLOCK key.
The indicator light will change from RED to
GREEN indicating the drive is unlocked and can
be accessed..
Changing the ADMIN PIN to your own unique PIN code
3
1
2
UNLOCK button
LED Indicator lights
2
3
1
CANCEL button
cancel
To Next Page
Need help?
General
