iStorage diskGenie User Manual

www.istorage-uk.com
10
You can change the Admin Password by doing the following:
Enter Admin Mode (refer to page 9 for details).1.
Press and hold + 9 until the indicator light ashes blue.2.
Enter the new password and press (The Password must be a minimum of 3.
6 digits and a maximum of 16 digits). The indicator light ashes green three
times. See note below.
Re-enter the new Admin Password and press . The indicator light stays 4.
solid green for two seconds and then solid blue indicating the Admin Password
has been changed successfully.
Note: If the indicator light ashes red three times, this indicates that the
password is less than 6 digits or more than 16 digits. Enter a
password that contains 6 – 16 digits after the indicator light ashes
blue intermittently.
If the indicator light ashes red intermittently and then blue intermittently, 1.
go back to step 3. This is due to one of the following conditions:
You waited longer than 10 seconds before entering a password.•
The new password was entered incorrectly.•
If no activity is detected within two minutes in the Admin Mode, the 2.
iStorage diskGenie will return to the Standby Mode.
Password Management
Changing the Admin Password
This section provides information about managing your password in the Admin
Mode and User Mode.

iStorage diskGenie Specifications

General

Brand	iStorage
Model	diskGenie
Category	Storage
Language	English