GENERAL INFORMATION
19
Loctite 242 Blue
Loctite 262 Red
Loctite 271 Red
Deter-
Bolt hole Dent mina
tion
3. Locktite
Caution: When the application method is being designated in the repair manual, follow the designation.
Dent
Apply onto the bore surface
of the bolt hole.
Specified bead width
(Reference)
Anaerobic : 2 ~ 3 mm
Others : 2 ~ 6 mm
Types Colors Work procedures
1. Wipe the thoroughly remove oil, grease and moisture from
the mating surfaces such as the bolt surface, bolt hole,
thread surface of the nut.
2. Apply Locktite.
3. Tighten the bolt at the “specified torque”.
Caution: After tightening the bolt, do not apply excessive
torque or vibrations for “about an hour” until the
applied Loctite sets.
Apply over the tip end
surface, namely 1/3 of
the threaded section.
To Next Page
Loading...
