DRIVING
- 4–24 -
4JB
1. Operate the priming pump on the
water separator to bleed the fuel
system air into the injection pump.
2. When you have finished the bleeding,
start the engine with the starter switch.
3. If the engine does not start within ten
seconds, repeat the bleeding
operation.
4JH
1. Confirm that sufficient fuel is held in
the fuel tank.
2. Operate the priming pump until it
becomes hard to push.
3. Turn the starter switch to "START"
position to start the engine.
CAUTION
Do not keep the starter switch in
the "START" position for more than
about 10 seconds. If the engine does
not start, wait more than about 30
seconds, then try starting the engine
again. If you try three times and the
engine does not start, perform step 2,
then try starting the engine again.
4. After starting the engine, remain in
idle for 1 minute. If the engine stalls
when in idle, perform step 3 and then
start the engine again.
5. Fully depress the accelerator pedal to
increase the engine speed. When the
engine speed reaches its maximum,
immediately release the accelerator
pedal and return to idle. Repeat this
operation three times.
QKR-IE-14424805234ALL.indb4‒24QKR-IE-14424805234ALL.indb4‒24 2017/09/2713:34:502017/09/2713:34:50
To Next Page
Loading...
Need help?
General
