SERVICE AND MAINTENANCE
- 5–66 -
NOTE
Use the recommended engine oil.
(Refer to "RECOMMENDED FLUIDS,
LUBRICANTS AND DIESEL FUELS".)
When the engine crankcase is filled to the
high level mark on the oil dipstick, start
and let the engine idle for a few minutes.
Stop the engine and recheck the oil level
and replenish, if necessary.
(F)
(D)
Changing transmission oil
Drain the transmission case by removing
the drain plug (D) on the lower face of the
transmission case. Fill the transmission
case to the filler plug (F) with the specified
engine oil through the filler plug hole.
WARNING
Right after driving, the oil may be
hot, so be careful.
Changing differential oil
Drain the rear axle case by removing the
drain plug (D) on the lower part of the rear
axle case. Fill the rear axle case to the
level plug (L) with specified gear oil
through the level plug hole.
Use GL-5 Gear Lubricant of the correct
viscosity for the existing ambient
temperatures.
QKR-IE-14424805234ALL.indb5‒66QKR-IE-14424805234ALL.indb5‒66 2017/09/2713:34:592017/09/2713:34:59
To Next Page
Loading...
Need help?
General
