SERVICE AND MAINTENANCE
- 5–67 -
(B)
Changing power steering fluid
Draining:
1. Jack up the front wheels until they are
clear of the ground.
2. Remove the fluid pipe (A) between the
steering unit and the fluid reservoir,
and the fluid hose (B) between the
pump and the fluid reservoir.
3. When draining is completed, remove
the remaining fluid within the hydraulic
system by turning the steering wheel
until it stops in both directions several
times.
(A)
To fluid reservoir
Refilling:
1. Install the fluid pipe and hose securely
and fill the fluid reservoir with the
specified automatic transmission fluid.
2. When the fluid reservoir is filled to the
specified level, allow 2 or 3 minutes.
NOTE
After refilling regularly check and keep
fluid reservoir replenished as
necessary to prevent air from entering
the hydraulic system.
4JB
3. Lower the front wheels to the ground.
Start the engine and let it idle for a few
minutes.
Recheck the fluid level and replenish if
necessary.
QKR-IE-14424805234ALL.indb5‒67QKR-IE-14424805234ALL.indb5‒67 2017/09/2713:34:592017/09/2713:34:59
To Next Page
Loading...
Need help?
General
