iSystem iC5000 Hardware Reference

 iSYSTEM, October 2016 51/69
 16-pin 2.54mm Infineon JTAG Cable Adapter
Ordering code
IC50160
This adapter is used to connect the iC5000 / iC5500 / iC6000 development system to Infineon XC166, XC2000
and TriCore based target via JTAG debug interface. It connects to Debug/Trace module on one side and to the
target debug connector on the other side. It can be used for targets featuring 16-pin 2.54mm pitch target debug
connector with Infineon JTAG pinout.
The following pinout is valid on the target side:
Signal
direction
Signal description
Signal
Pin
Pin
Signal
Signal description
Signal
direction
O
Standard JTAG
TMS
1
2
VTref
Reference voltage
I
I
Standard JTAG
TDO
3
4
GND
Ground
O
(optional)
CPUCLK
5
6
GND
Ground
O
Standard JTAG
TDI
7
8
RESET
Power On Reset
O
O
Standard JTAG
TRST
9
10
BRK_OUT
Break Output
I
I
Standard JTAG
TCLK
11
12
GND
Ground
O
Break Input
BRK_IN
13
14
OCDS_E
(optional)
O
Not Connected
NC
15
16
NC
Not Connected
16-pin Infineon JTAG target pinout
Mandatory pins on the microcontroller side are TMS, TDO, TDI, TRST, TCLK and RESET. BRK_IN and
BRK_OUT signals can be used optionally.
Note: 16-pin 2.54mm Infineon JTAG Cable Adapter features resettable fuses on all connected pins. These
protect debug signals against overcurrent and cycle back to a conductive state after the excessive current fades
away.
The adapter connects to the target via a 16-pin 2.54 mm connector (for example Yamaichi: FAS-1601-2101-2-
OBF). A target should feature a matching part (for example WÜRTH ELEKTRONIK: 612 016 216 21).

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English