iSystem iC5000 Hardware Reference

 iSYSTEM, October 2016 61/69
 14-pin 2.54mm Renesas SuperH Cable Adapter
Ordering code
IC50173
This adapter is used to connect the iC5000 development system to Renesas SuperH based target. It connects to
Debug/Trace module on one side and to the target debug connector on the other side. It can be used for targets
featuring 14-pin 2.54 pitch target debug connector with SuperH pinout.
The following pinout is valid on the target side:
Signal
direction
Signal description
Signal
Pin
Pin
Signal
Signal description
Signal
directio
n
O
Debug JTAG
TCK
1
2
NC
Not Connected
O
Debug JTAG
NTRST
3
4
ASEMD
Status read
I
I
Debug JTAG
TDO
5
6
GND
Ground
O
Mode select
ASEBRK
7
8
VTREF
Reference voltage
O
O
Debug JTAG
TMS
9
10
GND
Ground
O
Debug JTAG
TDI
11
12
GND
Ground
RESET IN
RESET
13
14
GND_DETECT
Ground detect
I
14-pin SuperH target pinout
Note: 14-pin 2.54mm SuperH cable adapter features resettable fuses on all pins except for pin 14, where serial
resistor of 100ohm and pull up resistor of 10k ohm is used. These fuses protect debug signals against overcurrent
and cycle back to a conductive state after the excessive current fades away.
The adapter connects to the target via a 14-pin 2.54 mm connector (for example Yamaichi: FAS-1401-2101-2-
OBF). A target should feature a matching part (for example WÜRTH ELEKTRONIK: 612 014 216 21).

iSystem iC5000 Specifications

General

Brand	iSystem
Model	iC5000
Category	Measuring Instruments
Language	English