To Next PageTo Next Page
Need help?Do you have a question about the ITATOOLS ITA11 and is the answer not in the manual?
General safety guidelines for operating the tool.
Details of the 12-month warranty period and its limitations.
Specifies requirements for connecting the tool to a compressed air supply.
Important warnings before operating the tool without strap.
Adjusting the welding/cutting time using a screwdriver.
Adjusting the strap tension using a screwdriver on the pneumatic motor.
Adjusting strap tension with an optional clutch system.
How to convert the tool for different strap sizes.
How to wrap the strap and feed it into the tool.
Steps for tensioning, cutting, and welding the strap.
Releasing tension and removing the tool from the strap.
Visual inspection of the strap seal quality.
Essential safety steps before performing maintenance or cleaning.
Step-by-step guide for replacing the cutter blade.
Step-by-step guide for replacing the feedwheel.
Replacing the strap locking plates on the base plate.
Replacing the welding gripper (foot).
Identifying and resolving issues with insufficient strap tension.
Diagnosing and fixing problems with the feedwheel sliding or damaging the strap.
Troubleshooting strap breakage during the tensioning process.
Addressing strap curving, incorrect seating, and seal alignment issues.
Identifying and fixing air leaks in the pneumatic system.
Resolving issues with sealed strap being too marked or breaking.
Resolving issues with the tool not releasing the strap after sealing.
Addressing difficulties in adjusting or maintaining the sealing time.
Troubleshooting tool removal from package after cycle.
Comprehensive list and visual diagrams of all available spare parts.
Specifies the model covered by the declaration.
Describes the type of machine (pneumatic plastic strapping tool).
General
