UPDATE, RESTART, AND ERASE
Update Smartwatch Firmware If there is a new firmware update available for your iTech Fusion, you
will receive a pop-up notification to download it within the iTech Fusion app. If you do not receive
said notification, tap the device icon from the navigation bar. Then go to Update Firmware where
you will see a red dot on the Update Firmware tab, signifying that an update is available. Tap the
Update button to begin updating your iTech Fusion. Be sure that your Smartwatch remains within
Bluetooth range of your phone while updating. Once your update is completed, your watch will
automatically reset.
Restart Your Smartwatch: If you can’t sync your iTech Fusion, or if you have trouble with connected
GPS or tracking stats, you can restart your smartwatch from your wrist. From the main clock face,
swipe down to reveal the notification panel and tap on settings. When in settings, scroll down to
‘Power Off’ and tap on it. Tap on the blue check mark that appears next to power off your device.
Allow your device a few minutes to fully shut down. Then tap and hold the screen of your device for
3-5 seconds to turn it back on to complete your restart.
WEAR AND CARE
All iTech Wearable products are meant to be worn all day and night, so it’s important to follow a few
simple guidelines as you wear and care for your device.
To keep your band clean and your skin happy, we recommend the following tips:
• Clean your band and wrist regularly - especially after intense workouts or sweating.
• Rinse the band with water or wipe it with a small amount of rubbing alcohol. Do NOT use hand
soap, dish soap, hand sanitizer, cleaning wipes or household cleaners, which could get trapped
beneath the band and irritate your skin.
• Always pat dry the band before putting it back on
Note: Although the iTech Fusion is IP67 water resistant, it is not IP68 waterproof which
means you should not submerge your smartwatch in water deeper than one meter for lon-
ger than 30 minutes. We advise not to swim with your device. However, your iTech Fusion
can withstand many splashes, rain, and daily activities such as washing dishes. If your
Smartwatch gets wet, we advise you to remove it until dry. It is not good for your skin to
wear a wet band for long periods of time.
IMPORTANT TIPS: If you have allergies, asthma, or eczema, you may be more likely to experience a
skin irritation or allergy from a wearable device. If you start to experience skin irritation or redness on
your wrist, remove your device. Contact a dermatologist if symptoms persist longer than 2-3 days of
not using your wearable device.
To Next Page
Loading...
Need help?
General
