ITech IT6300 Series User Manual

Function and Features
Copyright © Itech Electronic Co., Ltd. 22
 USB
Select communication mode via USB interface.
 LAN
Select communication mode via LAN interface. Before using the power
supply to communicate with the host computer, you must set the relevant
parameters to ensure that the power supply configuration is consistent
with the configuration of the host computer.
Memory Group
You can store up to 36 different operating states in a nonvolatile memory
space. All saved parameters are divided into four groups. They are Grp1,
Grp2, Grp3 and Grp4. Each group can save 9 different operating states (1~9).
Command
This item set the communication protocol. Possible settings are SCPI, EXT1
and EXT2. Default setting is SCPI.
Return Meter
This item enable(“Wait5Sec”) or disable(OFF) the function to turn back to
meter state automatically. When select “Wait5Sec”, the display on front panel
will automatically change to meter state under the condition of no operation
within 5S.
Reset
If you enter this menu and select “YES”, all parameters will be set to their
default values. The default configuration menu setting is as follows:
Out State
OFF
Out Param
Keep
Knob
UnLock
Buzzer
ON
Communication
RS232
Ext Port
None
Memory Group
Grp1
Command
ITECH
Return Meter
Wait5Sec
System
This item set the max voltage and out timer of each channel. Choose one
channel and set the parameters.
Max Volt
The max voltage you set should be within the range of 0V to the maximum
rated voltage. You can edit this value using the , keys or via numerical
key pad followed by . The default setting is the maximum rated
voltage for each channel.
Enter

ITech IT6300 Series Specifications

General

Brand	ITech
Model	IT6300 Series
Category	Power Supply
Language	English