Function and Features
Copyright © Itech Electronic Co., Ltd. 23
Out Timer
This item sets the output timer for each channel. The range is 0.1~99999.9S.
If you enable this function, and the output state of all channels is on, the timer
will start counting down immediately. If you do not need this feature, set it to
Disable.
Comb
This item configures the instrument connection mode. The options are Off,
Series, Para, Track. Data save and recall operations are not supported in
Series/Para/Track mode.
Off
Off means that each channel operates independently. When set
successfully, front panel will display “Remove success!”
Wiring in OFF state
Series (Series mode)
This function configures the instrument for series operation of CH1 and
CH2. Press button to confirm your set. And press to quit
the operation.
When enable series connection mode, the front panel will indicate “Series
success!” and escape this screen after 2S.
Front display as follows in condition of output off and meter state.
Wiring in serial mode:
To Next Page
Loading...
Need help?
General
