ITech IT6300

Output Commands
Copyright© Itech Electronic Co., Ltd. 29
Arguments
0.1-99999.9
Unit
S
Query syntax
OUTPut:TIMer:DELay?
OUTPut:TRACk[:STATe]
This command is used to set the following state of channel CH1+CH2.
Command syntax
OUTPut:TRACk[:STATe]
Arguments
0|1|ON|OFF
Query syntax
[SOURce:]OUTPut:TRACk[:STATe]?
Note: If channel 3 and channel 1 or channel 2 are in series or parallel or
synchronized state. Then an error occurs after this command is executed.
OUTPut:SERies[:STATe]
This command can set the serial state of CH1+CH2.
Command syntax
OUTPut:SERies[:STATe]
Arguments
0|1|ON|OFF
Query syntax
OUTPut:SERies[:STATe]?
Note: If channel 3 and channel 1 or channel 2 are in series or parallel or
synchronized state. Then an error occurs after this command is executed.
OUTPut:PARallel [:STATe]
This command can set the parallel state of CH1+CH2.
Command syntax
OUTPut:PARallel [:STATe]
Arguments
0|1|ON|OFF