Remote Control
Copyright© Itech Electronic Co., Ltd. 11
2. Use left/right key or rotate the knob to select Config > Communication and
press [Enter] to confirm.
3. Use left/right key or rotate the knob to select LAN and press [Enter] to
confirm.
4. Use left/right key or rotate the knob to select Restore and press [Enter] to
confirm.
–
NO: indicates refuse to reset the LAN to the default settings.
–
YES: indicates reset the LAN to the default settings.
5. After the setting is completed, press [Esc] to exit.
6. Restart the instrument and the modified configuration item will take effect.
To Next Page
Loading...
