ITech IT6512 - Navigating the Menu System

Command syntax：STATus:QUEStionable:ENABle <NR2>
Parameter:0~65535
Default set：Refer to *PSC command
Example：STATus:QUEStionable:ENABle 128
Query syntax：STATus:QUEStionable:ENABle？
Returned parameter：<NR2>
STATus: QUEStionable:NTRansition
This command is used to edit the negative transition trigger register of operation event. The
parameter determines which bits of operation event register is 1 will cause the OPER of
status byte register to be 1.
Command syntax：STATus: QUEStionable:NTRansition <NR1>
Parameter:0~255
Example：STATus: QUEStionable:NTRansition 128
Query syntax：STATus: QUEStionable:NTRansition？
STATus: QUEStionable:PTRansition
This command is used to edit the positive transition trigger register of operation event. The
parameter determines which bits of operation event register is 1 will cause the OPER of
status byte register to be 1.
Command syntax：STATus: QUEStionable:PTRansition <NR1>
Parameter:0~255
Example：STATus: QUEStionable:PTRansition 128
Query syntax：STATus: QUEStionable:PTRansition？
STATus:OPERation[:EVENt]?
This command can read the parameter from operation event register. After executing this
order, operation event register is reset.
Query syntax：STATus: OPERation [:EVENt]?
Parameter: None
Returned parameter：<NR1>