ITech IT6512 - RS-232 Connection Guide; RS-232 Communication Troubleshooting

inquiry syntax：SEQuence:CURRent? <NR1>
return parameter：MIN~MAX
SEQuence:WIDTh
This command is used to edit the width of specified step of the sequence file .
Command syntax：SEQuence:WIDTh <NR1><,NRf>
parameter：Parameter1 represents the number of steps to be edited.Parameter2 is the time
width (0.001~65.535).
unit：s
inquiry syntax：SEQuence: WIDTh? <NR1>
return parameter：0.001~65.535
SEQuence:SLOPe
This command is used to edit the slope of a specified step of the sequence file, this command
is only effective for IT6512/IT6513.
Command syntax：SEQuence:SLOPe <NR1><,NRf>
parameter： Parameter1 represents the number of steps to be edited.Parameter2 is the
slope(0.001~65.535).
unit：s
inquiry syntax：SEQuence:SLOPe? <NR1>
return parameter：0.001~65.535
SEQuence:SAVe
This command is used to save the sequence file.
Command syntax：SEQuence:SAVe
Parameter:None
4.10 Calibration Commands
CALibration:SECure
This command is used to enable or disable the protection mode.
Command syntax：CALibration:SECure {<0|1>,[<password>]}